i want interview questions about PROCESS CONTROL
INSTRUMENTATION ,
SENSORS AND TRANSDUCERS IF ANY BADY KNOW ABOUT THAT PLEASE
SEND TO MY MAIL karumudi1003@gmail.com
Answer Posted / ralf
Qualified applicants will know instantly that you are faking
it. If this knowledge were this easy to obtain you would
not have a difficult time finding qualified applicants. By
faking it you will only recruit people who know no better.
Best wishes.
Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
How r the calculation of process line mpm.
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
Explain bernoulli’s theorem.
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
what is span value and zero ? and how set ?
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
this site is owned by an nonsense
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
how can leve transmetter calibate in feild .and also put cv and flow plz .....
How would you choose differential range?