Interested to Buy Any Domain ? << Click Here >> for more details...
what is the funtion of conservator in transformers?
- 7 Answers
- 39272 Views
- I also Faced
- E-Mail Answers
Answer Posted / prashant
conservator is also used for OLTC (on load tap changer). OLTC also needs oil for its smooth working and for cooling purpose as for transformer.conservator actually works for oltc.
| Is This Answer Correct ? | 20 Yes | 13 No |
Post New Answer View All Answers
What is the general system requirement of alternator?
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?
power transmission pole used one support , that only for support or earthing
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
What is size 00, 01, 1 etc., in HRC fuse types?
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
WHY IN AC DRIVES,INPUT PHASE CURRENT SHOW UNBALANCE?
Single line diagrams for star to delta and DOL starters.
Ratings of power transformer,Distribution transformer.
Initially, when the input is not equal to the output — what type of response is this?
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
what are the applications of TIG welding
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
IN 1000kva transformer where the oil and winding temperature sensors is connected
what should be the acceptrd value of winding resistance for 2.5MVA transformer
