What is the Frequency while we step up the voltage from
220V to 11KV? Is it possible? Explain it?
- 6 Answers
- 8091 Views
- I also Faced
- E-Mail Answers
Answer Posted / shan80
The working principal of transformer is step up / step down
voltage without any chage in frequency.
So frequency remains same at both sides step up side or
step down side, normaly it is 50Hz.
| Is This Answer Correct ? | 19 Yes | 0 No |
Post New Answer View All Answers
The metal-enclosed switchgear and controlgear is subdivided into three types: 1. metal-clad switchgear and controlgear; 2. compartmented switchgear and controlgear 3. cubicle switchgear and controlgear. What is the main differnence between them. State some example.
what's the exact magnitude of current, flows through Neutral?
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
Define de-sensitivity?
what is 3rd Harmonics? how it is generated in alternator
what is the difference between general inverter and solor inverter clerly explain plz
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
where is core-type and shell-type construction suitable for transformers ?
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
What are the various types of rotor used in the alternators?
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
