Answer Posted / prakash gokhale
Because in tradition resistance type starter at the time of
starting the motor jerks produced, while in soft starter
motor startes sfotly without producing jerks. Also the
voltage is lower then the traditional starters.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
State and define ohm’s law?
in my working site. momentary jerck in electrical supply ocurred frequently which cause of multiple losses in our electrical equipements. how can we protect our electrical machines and equipements in this situation.
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
Z transform is use when system is not a) converges b) diverges
Post possible questions for Power Factor Panel FAT / SAT
Explain and give examples about VCB?
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
What is Auto Mains Failure Panel & Auto Synchronizing Panel
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
how to control dc motor?
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
Tell me in detail about c.t. And p.t. ?
Ceiling Fan and Storage type water heater. Discuss
When color of silica gel will gets change from blue to pink from Top to bottom?
