i want interview questions about PROCESS CONTROL
INSTRUMENTATION ,
SENSORS AND TRANSDUCERS IF ANY BADY KNOW ABOUT THAT PLEASE
SEND TO MY MAIL karumudi1003@gmail.com
Answer Posted / jithu
first of all u study basics of the instrumentation regarding
with measurement parameters and their measuring methods also
the equipments used for that ,,
Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
what are procedure of sox-nox calibration
How many ohms are required for proper earthing?
What are the interlocks we have to check during the start up of LP/HP compressor?
Explain about the leakage class of the control valves
How will you calibrate PID controller? explain with example.
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
what is function of switch, and how is it work, explain with difination
what is the working principal of pribe
why we are using magnet for calibration of gas detector?
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
How the sizing of the analog signal cable is calculate?
How to calibration coriolis flow meter?
how u calibrate pneumatic n motorized c/v?