To check the earth condition (In plug points); the voltage
between earth and Neutral is in below 5 volts. Is it
correct
- 6 Answers
- 7059 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanjiv
Earthing depend of area of humidity.Costa area 5volt is ok but dry area 8volt is ok.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
Why do we use center tap transformer that used with portable tools
Why power factor should not be in leading (capacitive) mode of any load.
how many types control panel of a 132/33 kv substation
How many types of circuit loads are there in a common electrical circuit?
How can I calculate the Mega watts required to run a plant having many electric motors and other electrical components.
what is earth pit , how we can measured it, what earth rods reference
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
Can we use both Electrical & mechanical interlock between tow breakers? if yes how, please explain
What the main causes of transient interruptions on Over-Head Distribution Lines?
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
what is the efficiency of thyristor
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
what is difference between window type and wound type transformers?where we will use window type and wound type transformers?
