Why indicated only R.Y.B to phase.

Answer Posted / shan80

it become common to indicate phases with r,y,b and it not
necessery to indicate phases with r,y,b u should indicate
them with l1,l2,l3 also with r,s,t

Is This Answer Correct ?    5 Yes 7 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

The metal-enclosed switchgear and controlgear is subdivided into three types: 1. metal-clad switchgear and controlgear; 2. compartmented switchgear and controlgear 3. cubicle switchgear and controlgear. What is the main differnence between them. State some example.

1490


how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?

2190


I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?

1534


sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.

1490


What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?

1614






if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?

1525


How energy is generated in hydroelectric power plant?

634


sir i am apearing for nic exam.i dont know exam pattern.can you please send me some model papers

1503


Can a generator runs after getting 1st stator earth fault.

956


1. How many types of mangers? 2.How many types of capacitors? 3.pls tell me normally types alternator problems?

1721


What are the advantages of stationary armature and rotating field system?

704


tell me some type of questions throught which i can prepare for exam and do my best

1550


Why the power factor improvement is so important in industrial loads

1404


Explain the laying procedure and laying depth of submarine/subsea power cable for 220/400KV system? Also available cable diameter?

1694


What is the formula to calculate the rating of a three phase miniature circuit breaker

1666