Answer Posted / ravi
all r right
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
description about dry type transformers
how test transfomer(3 phase75kva) by megger
What is Load sharing of Transformer ?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
HOW TO CALCULATE CAPACITOR BANK OR HARMONIC FILTER CALCULATION
ELECTRICAL DRIVES: can a motor load system with passive load torque can have equilibrium speed in second quadrant
volts=230 c=10mf a=??
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
what is laser diodes?
what is the advantages og idmt relay over magnetic relay??
What information we need to prepare relay coordination chart
