Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between AC voltage and DC voltage?
- 6 Answers
- 19444 Views
- I also Faced
- E-Mail Answers
Answer Posted / priti
Direct current or DC electric motors work for situations where speed needs to be controlled. DC motors have a stable and continuous current. DC motors were the first and earliest motors used. They were found, however, to not be as good at producing power over long lengths. Electric companies found using DC motors to generate electric did not work because the power was lost as the electric was transmitted. Brush DC motors use rings that conduct the current and form the magnetic drive that powers the rotor. Brushless DC motors use a switch to produce the magnetic drive that powers the rotor. Direct current motors are often found in appliances around the home.
Alternating current or AC electric motors are used differently based on what type of AC motor it is. Single phase AC motors are known as general purpose motors. They work well in many different situations. These AC motors work great for systems that are hard to start because they need a lot of power up front. Three phase, also called polyphase, AC motors are usually found in industrial settings. These motors also have high starting power built transmit lower levels of overall power. AC power gets its name from the fact that it alternates in power. The amount of power given off by an AC motor is determined by the amount of power needed to operate the system.
| Is This Answer Correct ? | 8 Yes | 4 No |
Post New Answer View All Answers
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
as a electrical student why should i hire you?
WHY THE RATINGS OF THE TRANSFORMER IS 33KV WHY NOT OTHER???
How to Decide the Location of Earth pit for Compressor in Oil Depo? and How to measure the resistance of earth pit Pls explain me with the help of Circuit Diagram?
is there any role of power factor with frequency variation? and how we can manage the frequency variation?
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
in basic 2 phase will short means tripping the power but spot welding 2 phase shorting but not tripping it will welded why.....(Q)
how many joint can done in HT line and what is life of the joint
What is Antipumping Function & If we have C.T how we find the Ratio ?
th how could we differentiate between armoured copper and armoured aluminium cable what is the basic application? why we prefer the armoured copper as compared to armoured aluminium.
low frequency protection why recomend?
detailed procedure how we calculate cost for pcc m10 and rcc m20 including centering and labour excluding steel/ iron
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
What conditions are required for transformer to operate at low frequencies ?
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
