Answer Posted / ashok bhatnagar
It is Kilogram per meter cube or kg/m3
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
How to synchronization will be done between two DGs ?
Define branch?
What is the minimum underground tank size capacity considered for firefighting purpose?
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?
How do we calculate over and under frequency tolerance from generator data?
what is the difference between circular wdg & ractangular wdg?
what is diff. between earthing grid,earthing mess, earting grid?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
Define demand factor?
what is fault level of power system ?
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
What is quadrantal symmetry?
