what is difference between RTD , thermo couple and
thermistor in general ?? (except temperature co-efficient )
- 5 Answers
- 17139 Views
- Bilt, I also Faced
- E-Mail Answers
Answer Posted / rajendra shaha
in general RtD and thermister is passive transducer and
thermocouple is active transducer
| Is This Answer Correct ? | 51 Yes | 4 No |
Post New Answer View All Answers
KAlman filter code for two dimension?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
Any body have know try work calculation ???
Using your own examples solve a problem involving normal table. (experimental method and analysis)
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
What is the difference bitween control net scaner and device net scaner
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
How we calculate orifice plat size???
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
What is difference of fanuc alpha series 16i and 18i controller.also what is differnce betn TC and MC controller
What is Cavitation in a control valve?
