Explain principle of Soft-starter & how its working???
- 12 Answers
- 25930 Views
- MAHINDRA, I also Faced
- E-Mail Answers
Answer Posted / sushil
In soft staretr current is gradually increased which is
save the power loss & also the motor friction in
unnecessarily used.
| Is This Answer Correct ? | 22 Yes | 16 No |
Post New Answer View All Answers
100 MVA 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase. what will be the fault MVA of generator.
What is Icu and Ics and what is difference b/w them. please tell me how to calculate a size of a copper bar for a system or a breaker... reply on... king.arish@gmail.com would be waiting for a logical answer.
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
What does ampere turns shows?
What is the formula to calculate distribution transformer De-rating on iron losses basis
In CTs tan delta point should be earthed , what is the reason behind it?
what is the preventive maintence for ht panels and busbars and vcb abd acb's.
what will be the effect if you were using different brands of outlets?
what is the reason for indication of light in the earth lamps of main switchboard.if there is an earth why does one lamp get dim and the other two bright.
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
If Polarization index of motor 8.75 at 500volts of medium voltage 4.16 KV motor what this mean winding good or bad pl answer if any reffrence book give me the link
operation of diesel generator
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible
