why autotransformers are not safe for supplying low voltage
from a high voltage source?
- 5 Answers
- 12102 Views
- I also Faced
- E-Mail Answers
Answer Posted / bhigesh
al type transformers are step up tramsformer.its aim to
decrease voltage at the keys of independent voltage inverter
| Is This Answer Correct ? | 0 Yes | 12 No |
Post New Answer View All Answers
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
Which do you think is the most significant cause of energy loss in a factory?
WHAT IS THE TECHNICAL SPECIFICATION OF C CURVE & D CURVE LEGRAND MAKE MCB
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
In a flange coupling, the flange bolts are designed for
what is sevice settings for mccb?How can be it setted?
why Lightening Arrester Probe sharp at Top of telecom tower.
1.main parts of generator? what is used A-check,B-check,C- check? 2.what is FM200 system in data centers? 3.difference between pac,ahu?
What is the size of a 60 watt and 80 watt tubelight?
what are safety measures in /control in diesal engine/ explain them?
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
how many joint can done in HT line and what is life of the joint
