voltage at generation stage is usually- ?
a.11kv b.33kv c.66kv d.220kv
- 12 Answers
- 18284 Views
- I also Faced
- E-Mail Answers
Answer Posted / mallesh.s
11kv,after generation we can vary it to desired value
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
where lt & ht capacitor used
HOW TO CALCULATE EARTHING SIZING?
where solid grounding and where grounding through ngr done and why?
What is meant by impedance? difference between high & low impedance ?
Which type of transformer is used for lighting loads?
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
what exactly commisioning work does in electrical site work... LT side?..
what is the formula for hv test for cable and circuit breaker..????
what is meant by tranformer impedance?
ht side line to earth voltage
How can I model an open-delta ground transformer for a network supplied by 4 unit GTG and power transformer in ETAP?
Explain the advantages and disadvantages of thermal power plant?
Benifits of 3ph 4 wire metering over 3ph 3 wire
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
