Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference when selecting a cable between AC
and DC current?
- 13 Answers
- 55095 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / avd
It does not matter much for AC or DC. The rms value of AC
is equal to DC. However if AC voltage rating is high then
you should cosider additional heating of cable due to AC
loses.
| Is This Answer Correct ? | 23 Yes | 6 No |
Post New Answer View All Answers
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
What are the necessary components of the feedback control system?
how was your last weekend.
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
why they were using TRIAC instead relay in some controllers and what is the advantages.
would you please give me any idea about the BARC interview question on electrical? i have an interview on 1st july.....plz hlp me.......its urgent......
why not starting switch first connect in direct on line starter?????
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
Why let through energy not considered for ACB breaker while cable sizing?
1. Design a counter which counts 0, 4, 8, 2, 6, and repeats using: 1.a using JK flip flops 1.b using T flip flops 1.c using D flip flops
how to calculate voltage drop and followed by cable calculation?is there avail in formula?
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
Describe the test procedure to determine the vector group
why generator efficiency is more in swinburnes test?
What is superposition theorem?
