Answer Posted / utkal mishra
we know in series motor t=flux*armature current
as flux directly propertional 2 armaturecurrent
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
how to determine the inrush current of a transformer
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
What happens if the series current double?
How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...
what will happen if frequency is below 50 hz?
whatare the disadvantages occur,if the form factor of transmission will not be equal to 1.11
How eddy current generation support the idea of train braking?
What kind of preventive maintenance are there for transformer?
what is circuit recombiner and how it is different from circuit breaker
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
what is frequency response?
How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.
Post possible questions for Power Factor Panel FAT / SAT
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.