why we used shahabad stone (ladi) in box type water
proofing.what is the main roll of shahabad stone?
- 2 Answers
- 22090 Views
- I also Faced
- E-Mail Answers
Answer Posted / raajeev bedi
We use stone as it is non porous and hence is likely to resist water from seeping in. Moreover if sealed properly stone is most likely to give 100% waterproofing.
| Is This Answer Correct ? | 18 Yes | 6 No |
Post New Answer View All Answers
What is binding spacing of the rebars at lapping zones.
I am a civil engineer . I am also selected for sbi clerk interview which is to be held on 4th May2010 is there anybody resembling the same? what question can be asked and what should be the probable answers?
Why does the pressure increase under soil?
What is the method of soil replacement test?
undistributed samples are obtained by
how to calculate cut length of re-bar in a circle . because we not place same length of re-bar in whole circle maximum in center and minimum at corner so how to calculate middle bars???
how to convert cement, sand aggregate quantity from M3 to kg with full description?
Detection of a beam & a girder are––––
cement and sand required for one block of size 0.23*0.15*0.46
The largest size of paper used in plotter to print the drawing made by Autocad .
How much for the BRC lapping in full yield and half yield < and which table to get it ?
what is labour consume factor in residential projects
what are RIB slabs explain about it
100mm block work 64 bags of cement used 150mm block work 286 bags of cement used 200mm block work 20 bags of cement used patly work (M15) 293 bags of cement used mortar ratio is 1:5 how to calculate volume of sand in cum & no. of bags
Types of column foundation and how to calculate its steel quantity.
