Answer Posted / rawat
Have a battery fully charged. Take a variable resistance bank. Connect the batteries across the resistor bank. Set a value of discharge current to a fix value by adjusting the resistance. Note down the voltage per cell continuously. When the battery cell voltage drops down from fully charged voltage to end cell voltage note down the time duration. The continuous current during discharge in ampere multiplied the time duration in hour will give you AH of the battery.
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
how balanced in star delta connection ?
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
Difference between a pilot wire and a normal conductor?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
What is contract demand in solar system?
What is routh hurwitz stability criterion?
Difference between ac parallel circuit and ac series circuit?
I want to make street light with solar system ... What may I do for procedure and how much of estimation for each material ... If any one knows guide me and inform this id : aravindd7@gmail.com
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
how to calculate transformer turn primary & secondary side 11kv to 420v
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
5.WHICH TYPE WELDING PROCESSES USES NON CONSUMABLE ELECTRODE.........
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
What Is Connection APFC Panel In Compony.
help me with the question that might be ask on the interview for technical position
