Answer Posted / rahul menon
We can use 1 RTD for temperature detection. When
temperature change, resistance also changes in RTD. This
RTD input can be given to a PLC and from the output of the
PLC a valve can be controlled based on RTD input. This
valve can inturn control the temperature of a container by
the valve ON/OFF operation.
| Is This Answer Correct ? | 12 Yes | 2 No |
Post New Answer View All Answers
how do you check pump impeller front clearance?
What is the purpose of cost accounting?
Share with us about a time when you had to present a proposal to a person of higher position and were able to do it successfully?
What kind of tools and materials are required to test water softening system of heating plant?
what is the current rating of both primary and secondary of 500kva,33kv./400v.distribution transformer?
Hoe electronic energy meter works?
how do you check pump impeller back clearance?
What is total quality control? Mention the technical standards.
What is quality management system? Weather qms is suitable, adequate and effective or not? Is there any quality policy? Is there any quality objective? If yes, then what are they? How they are planning to achieve quality objectives? Do they are measure quality objectives?
how to find rmc plant MD?
What is different between preventive maintenance and maintenance?
Why the thermocouple is a transducer an rtd is not a transducer both taking heat as a input and give millivilt and ohms.
What is v/f control, sensor less control and sensored control for ac vfd?
What happen if we install flow meter with orifice plate, but bevel position is in upstream and not in downstream
What is process analysis?
