what will be the difference in compressive test results for a
150 mm cube, a 150 mm cylinder and a 300 mm cube
Answer Posted / sjtbehera
The Specimen Size and shape effects on the compressive
strength. Diffrent size of cylinder of diffrent height nave
diffrence compressive strength. the diffrence between these
cubes is we don't compare these strength result with the IS
standard which has been tested in a standard cube.
Is This Answer Correct ? | 4 Yes | 8 No |
Post New Answer View All Answers
what is shuttering co efficient?
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
in the construction of residential building what type of tank are used?where?why & what is its purpose?
I have completed building maintenance course in mcvc stream .. can I apply for the post of " sthapstya abhiyantriki sahayyak"?
How much time Required for PPR pipe network testing
what is the design procedure for building
Design a cantilever slab to carry a live load of 2000 N/m2. The overhang of the slab is 1.20m. b) A slab over a room is 4.75m x 4.75m. The edges of the slab are simply supported and the corners are not held down. The live load an the slab is 300 Kg/m2. The slab has a bearing of 15cm. On the supporting walls. Design the slab as per Rankine - Grashoff theory. Assume weight of R.C.C. = 2400 Kg/m2.
what is thumb rule for calculating the size of ISMB required for a particular length of span
what"s the sort of beams?
How to hide dimensions in autocad?
What is the cost of shuttering per Sqm.? How it is calculate by thumb rule...?
What is bmc stands for in bmc software?
what is BPM in concrete demolition hammers. what is better a higher value or lower
Aptitude, reasoning, quants, verbal and technical question
How to calculate the load of partion in flat slab if we use brick?