Why TAP changer provided in primary side of HT
transformer ? and why not in secondary?
Answer Posted / yash
1. at HT side current value is less as compared to LT side.
2. insulatin requirement is less
3. tap changing can be smoother and it would have fine
control as no. of taps are more(due to low current)
Is This Answer Correct ? | 76 Yes | 3 No |
Post New Answer View All Answers
i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.
hi, i finished b.tech eee in 2008, im worked in dg sets mfg company , now i left job in 6months back, now again i want get job core side, how can i get? is there any couses we have learn to get better oppurtunity? /
what is the use of Auto re-closer?
what is the ms flat constant for calculating earth mat design calculation?
If anyone would like to know or practice for FEWA papers contact me on mohamedrashad2@hotmail.com Just completed the supervisor exam in April 2021
what is the relation between reactive power and power factor for the what is the limit of reactive power and power factor
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
Why efficiency in thermal power plant is low?
what work will do diffrential realay DG set
In HVDC LINE RECTIFIER CONTROL ON CONSTANT CURRENT AND INVERTER CONTROL CONSTANT EXITATION ANGLE CONTROL BUT HOW INVERTER CONTROL CONSTANT CURRENT?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
how to estimate wiring ins roughing ins. and boxes
Explain Active power,reactive power,how its related to each other , & inductive ,capacitive.
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
what is interpose? where it is used and why it is used?