Answer Posted / shantanu dash
The cable size of a motor mainly depends on the following
factors.
(i) Rated Current of Motor
(ii) Starting current and starting time of the Motor on
load.
(iii) Type of starters used for starting the Motor
| Is This Answer Correct ? | 75 Yes | 1 No |
Post New Answer View All Answers
Is there any question in the name of Static Switch in UPS??
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
Phase control and integral control are used for?
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
I have 440v power coming to facility,( not being used ) can I buy large generator, (gas) to sell power back to electrical co.
WHAT IS START TO INDUCTION MOTER IN STAR TO DELTA OF >5HP ?
which VFD is better ( LT or HT)
Why the earth to phase voltage is high 250 compare to other two phases
what is the principle of operation of CFL ??
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
What is lifting power for 1 wb/m2 and 1 A magnet?
On a 6 KVA UPS we have to provide a DC MCB for Battery bank of 16 nos (12 V 42 AH). What Shall be the current rating of DC MCB ?