why synchronization done in clockwise direction?
- 12 Answers
- 21797 Views
- Hindalco, NTPC, I also Faced
- E-Mail Answers
Answer Posted / anees ur rehman
I hope that answer 2 and 4 are v.good.Normally
synchronisation done at 1/10 frequency of incoming
generator kept higher thans the exisisting source.why.yes
when it is synchronised as generator take load its speed
decreases due to low frequency it will trip so its
frequency is kept 1/10 times more than source
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
operation of protection relay watchdog contact?
How to select HT/MV cable size ?
why ahould you show client/engineer activities clearly on the project plan
What is the effect of positive feedback on stability of the system?
what is the total power generation in india?
We have two parts in generator, electrical & mechanical. how it works?
How can we calculate the transformer rating if the load calculated is 1000KW (11Kv Supply)?
What is the Resposiblity of Electrical Utility Engineer
WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM
Why is better to have a minimum ceiling voltage of 250% than 160%?
Briefly describe your ideal job?
How vfd saving power.
what are the possible reaons & remedies if resistance of NGR getting heat up
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
