In which type of circuit short circuit is dangerous in
parallel or series and why?
- 6 Answers
- 8708 Views
- I also Faced
- E-Mail Answers
Answer Posted / vksumanth
ph-------o-------o-----o------n
in the above fig shows series combination, if any short occur in the circuit current increases and fail starting element only ckt opened.
-------o---------/
/ parallel /
/------o---------
u r understanding from above fig suppose branch1 element may short occur current raised in that branch ,because v same i not same.remaining ckt healthy.
SO IAM TELLING CLEARLY DANGER IS SAME ABOUT LOSSING OF APPARATUS.BUT IN PARALLEL ONLY SHORT BRANCH DAMAGED AND INTRUPTED REMANING BRANCHES OK.GOOD
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What are dependent sources?
what does a string of resistors in a series will do?
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
1.WHAT IS A SMART CAPABLE DB ( DISTRIBUTION BOX) ? 2. HOW TO DECIDE THE TYPE OF DB TO BE USED ( RECESSED/ PLUG TYPE/ SMART ETC ETC? 3. WHAT IS MILLENEUM BUS BAR USED IN DB? 4.DIFFERENTIATE MCCB AND MCB.
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
How can i get my certificate of competency as an electrical supervisor? I have complicated my B.Tech from Uttarakhand technical university this year (2012).
What is the working principle of CFL & T5 tube light & 40W tube light with electronic ballast?
XYZ
How relay coordination has to be done? what are the inputs are required for this? Please explain this with calculation method?
Define the term Capacitance and Inductance?
What is the type of earth fault protection used in battery? explain.
will there be any problem by recovering slip from single phase induction motors?
What are the three constants associated with a steady state error?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
hi there i am highly enthusiastic about discussing electrical concepts , and hence i wud lyk to invit al do intrested to join me at gtalk and hav a dscussun of the concepts , ad me as a freind . my email id is rakesh.2k99@gmail.com
