Definition of grid?
- 7 Answers
- 10769 Views
- L&T, Pace Power Systems, Vijai Electricals, I also Faced
- E-Mail Answers
Answer Posted / umair iqbal
An electrical grid is an interconnected network for
delivering electricity from suppliers to consumers.
| Is This Answer Correct ? | 20 Yes | 3 No |
Post New Answer View All Answers
Can anyone please provide me details of MCCB/Contactor/SFU rating calculations for a motor feeder..for example 50 kw.. not from type-2 cordination chart. i want manual calculations..
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
What is core CT & it's function?
After synchronization with grid what is the demand value QKVAR and how we will maintain that?
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
why we use circuit breakers for switching instead of normal switching device?
how to calculate the capacitor to maintain power factor?
what is the mechanical safety of DG ?
after how many spot we must chang secondry cable in portable spot welding gun?
When we connect the large capacitor bank in series ?
what is the transformer rush current?
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
The power supplied to a 50mH inductor from a 120V, 60Hz source will be
