Answer Posted / nikunj faldu
Management Integrated System
| Is This Answer Correct ? | 6 Yes | 10 No |
Post New Answer View All Answers
What is the density of Fiber reinforced concrete and give me the which fibers we can use in Concrete?
how i convert mm into standard wire guage (SWG)no.
construction workers how much time take one work or qty
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
What are some facts about concrete?
can you please tell me what the current rate of construction material and different construction labourers charge in bangalore ???
How to determine thee cut length for steel reinforcement bars in R.C.C design
how to calculate detail quantity of bricks and mortar for 500 cu.ft masonry work. consider wall thickness 9 inches
silt%= silt volume/ silt+sand volume is this right?
For plate load test why we are applying pressure 3 times the proposed allowable bearing pressure? Is there any supporting standards for this?
What is GSB gradation
what is the mix design for M:60 with micro silica andmetakaoline?
Pls help me to arrive the rates for centering shuttering for highbay using H-frames?
how much need cement bags for block work of wall approx 1000 hollow blocks 20x20x40cm
I used Etabs software to analyse a high-rise building. And I want to use templated UBC-codes inside to calculate the Seismic load. My question is: whether or not I have to control the seismic load by base shear load which is manual calculation? (just for more clarification: I can control this by input the scale factor into Eartquake definition in Etabs) I would highly appreciate your answer.