Answer Posted / sreekanth.yarramasu
a transformer is a static electromagnetic device designed
for the transmission of primary alternating current system
in to another secondary one of the same frequencies with
other characteristics in particulars other primary voltage
and current.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
Why we are use dol starter up to 10 hp
what is the difference between general inverter and solor inverter clerly explain plz
what is the difference between 2 way and 4 pole selector switch???
what is meant by rotating magnetic filed
how will we calculate the copper wire load..
Actuality I have at home electrical panel with 220v 50hz, and I want to converter from there to 110v 60hz, to wiring on the half of my house. Also I like to keep another half of my house with the original 220v 50hz. What is the best and safety way to do?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
how to find the torque of the single phase synchronous motor by doing an experiment
Why to keep capacitor bank off while generator running.
I need HT sphere gap calibration table. Can any body help me.
How Can You Relate Power Engineering With Electrical Engineering?
how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???
What is the magnetic field (coil DC ) of Turbo Expander?
