what is the working difference b/w softstarter and
Variable frequency drive ?
- 6 Answers
- 9114 Views
- Parle, I also Faced
- E-Mail Answers
Answer Posted / satyanarayana gupta
the main function of variable frequency drive is to
control speed of the motor according to the load it just
works as control system with feedback according to that
feed back it will change its speed
where as soft starter it will
just monitor the speed at starting time only
by using vfd's most of power consumtion is reduced
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
what is the ATS .And how it works.
Explain how you intend to work under pressure to meet up with deadline target?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
Which type of transformer is used for lighting loads?
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
why we are not giving the zone 1 trip command to the master trip relay
How to perform a DC resistance test In Alternator and their proceduces?
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
Is phenomenon of resonance is harmfull fr the machine? if not or if yes please explain it?
how to ctrl motor by use of ac or dc drive.plz explain evdintly
How is the connection of the tap changer on the HV side been made?
what are the necessary basic electrical topics to learn for mechanical engineer to deal practical problems.
11 kg trivevter meter has rating of -/5amps. And pt ratio11000/110v and is connected with 11kv ct/pt unit of cr ratio 75/5amps. And pt ratio of 11000/110v while checking accuracy of meter with HT Accuchek meter what value of PT ratio and CT ratio to be filled in Accuchek meter
sir, i am 3 years diploma course pass out candidate.what type of certificate can i got in marine service.
