Answer Posted / prince
Instrumentation Engineering by A.K Shaney
Is This Answer Correct ? | 15 Yes | 1 No |
Post New Answer View All Answers
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
What is difference between differential pressure & delta pressure?
how to convert cubic metre per hour to newton cubic metre per hour
what is dc moter.
Calibration procedure for Electro magnetic Flow meter
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
draw the block diagram of a level transmitter ?
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.
How to Calibrate Vortex Flow transmitter in field
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
Please can anybody help for control valve sizing step by step procedure?