If single phase voltage level is 230V than why three phase
voltage level is not 660V ?, but it is only 440V.
Answer Posted / bbhanj
Voltage is nothing but potential difference, so we can take
only 2 objects if we want to measure the difference between
them. So we always measure this difference of potential
between 2 not 3.
Is This Answer Correct ? | 21 Yes | 21 No |
Post New Answer View All Answers
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
How would your past experience translate into success in this job?
what is the usage of microcontroller in the panel board?
Enlist four components of electrive drives.
If we want to change a contactor of faulty one what are the conditions want to fullfil
what is the circulate the diesel in DG in side pls tell parts name and picture with circulate the diesel
Different types of relay fault which phase sequence??
does a DG set has low fault level as compared to that of a transformer.If yes then why.
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
Why the arms of delta in a delta-wye power transmission system are kept constant??
Capacitor is load free component but why ampere meter shows current when capacitor bank breaker close?
What Normal(Tangent) towers and Tension(Cut-point) Towers?
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
which type of motor is used in automatic swing gate