Interested to Buy Any Domain ? << Click Here >> for more details...
what is the safe meggar values for motor, transformer HT, LT
and Cables?
- 12 Answers
- 52023 Views
- IOCL, Jindal, TATA, I also Faced
- E-Mail Answers
Answer Posted / imran
Magger value must be more than 2 mega ohm minimum..
| Is This Answer Correct ? | 34 Yes | 19 No |
Post New Answer View All Answers
Explain what cmos is and its benefits?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
State angle criterion.
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
what is the method of earthing of a transformer using electrodes?
what is model question rrb junior engineer electrical gr.II
What is the magnetic field (coil DC ) of Turbo Expander?
How to Calculate The sag of OPGW in Transmission Line???
What is sink and source?
when elecromagnatic waves are propogated in a wave guide?
how was your last weekend.
what is ps impedance test
working principle a.v.r. ?
