can we configure multiple as on single router using eigrp
- 1 Answers
- 3776 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / shahin
Yes we can configure multiple AS on a single router using EIGRP.
For each AS, EIGRP maintains separate set of information
table, such as Neighbor table, Topology table & Routing table.
EIGRP also maintains separate set of information table, such
as Neighbor table, Topology table & Routing table for each
Routed Protocol (IP, IPX & Apple talk).
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
Explain the difference between arp and rarp?
What is the mac address?
Explain the difference between baseband and broadband transmission in ccna?
Suppose we have some switch in network and we are running RSTP how much convergence time will be there if one link down
In how many ways you can access router?
What is formula of hold down time of eigrp protocol?
If bandwidth will increase what will happen?
Which updates called incremental updates?
Can you explain the broader steps of how L2F establishes the tunnel?
in stead of 0.0.0.0 wild card mask what u can write after ip?
How do you go to privileged mode? How do you switch back to user mode?
How many valid ip will b in /21 in route summarization?
How do you configure a Cisco router to route IPX?
What is the network subnet?
Wild card mask always in odd value or even?
