WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN
DISTRIBUTION LINES?
- 6 Answers
- 6904 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / santosh maske
L.A placed below and IIrl to Distribution Line.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
Dry type transformers
What is meant by impedance? difference between high & low impedance ?
What is the theoretical reason for the size of a zig zag grounding transformer to be 1.732 times less than that of a wye-delta grounding transformer used for the same application?
Why frequency changes due to load variation in power system ? i.e why when load increases frequency decreases?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
what is doubling factor in making current of a breaker?
What are the various types of BUSBAR Schemes? explain each
What is self exciting?
Difference between ac parallel circuit and ac series circuit?
Mention the disadvantages of low power factor?
What does the term “voltage regulation” means?
What is the Temperature to be set in Thermostat provided in Marshalling box of the Transformer / Motor.
1.why we are using blocks in withoutgaplightning arrester 2.why we ar using bushing in withoutgap lightning arrestor
how we will deside the high voltage value
