what is the main purpose of line PT and bus PT?
- 11 Answers
- 73173 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / satale kiran
pt means the potential transformer, which is used as a
instrument transformer in measuring device. its main use is
to step down the voltage at measurment levels.
| Is This Answer Correct ? | 35 Yes | 34 No |
Post New Answer View All Answers
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
why is using sensor?what is differece between photoelectric and proxmitty?
what is differentila pilot supervision in the incomer control panel in the power station?
On what cycle does thermal power plant operate?
in what type of applications v can use q meter?
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
Can u explain : what is supply for train (whether a,c or d.c ).I know that supply is 25000v a.c .But there is rumour that supply is D.C. And also explain how lights and fans inside the trains are working ,and what type of motors are used in trains whether D.C motors or induction motors .If d.c motor, how it gets supply.If traction motors are used then what are traction motors and its functions and how it differs from other motors and also explain about locomotive . y d.c series motor in train.train wheels r driven by D.C shunt motor ,at what voltage,and at what speed. please reply..............
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Explain marx circuit.
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
What type interview questions ask in Electrical technicians
Why is the air gap between the pole pieces and the armature kept very small?
