Why should we use the igniter in the sodium vapour lamp.
- 7 Answers
- 68722 Views
- ABB, Delphi, Mudhra, NTPC, PICT, I also Faced
- E-Mail Answers
Answer Posted / ssreenu
In other words the purpose of Ignitor is just like a
starter in tube set.
| Is This Answer Correct ? | 41 Yes | 8 No |
Post New Answer View All Answers
How will change the frequency in distribution side?
Why 15Amp. MCB is suitable to carry load of 1.5Ton Ac please Explain?
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
static chagre
can we do the star delta connection of capacitor for 3- phase motor starter.
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
what is the purpose of using filters in a protective relaying scheme?
what is the function and use of cable differential protection relay?
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
wat is the current produced in a 5000v megger? when the positive and negetive terminals are touched on our body get s shock?
Why do we need interlocking in a HT metering or Ring main unit switchgear?
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
How does the slip regulator works as a startor
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
