Interested to Buy Any Domain ? << Click Here >> for more details...
1. Why a DC motor starter is called 3 point starter
- 21 Answers
- 80973 Views
- ABB, CG, College School Exams Tests, Crompton Greaves, Infosys, Siva, I also Faced
- E-Mail Answers
Answer Posted / saila sandeep
because it has three terminals i.e;'l' 'f' 'a'
'l' is connected to supply
'f' is connected to feild circuit
'a' is connected to armature
| Is This Answer Correct ? | 40 Yes | 7 No |
Post New Answer View All Answers
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
how does grading rings & spacers in transmission line works? Working Principle?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
what is meant by twilight switches 7 where its applicable ?
What is Electrical Grade Aluminum for Tubular BusBars. i am confused between 6063 and T6 or T5 and what is BS 2898 and BS 159?
what is buffer resistance starter.?.What is the working principle and where it is used..?
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
How to select a cable size for particular load?
Why is a plain induction motor unsuitable for wide speed control?
how i calculate the syncrones generator NGR resistance .if we have a 6mw generator line voltage of generator 11kv also line current 393.3 ampere.
how to define tell me about self
during installation time of transformer and alternator which points we have to observed?
wat is the first thing dat is needed, 2 lay a cable in some area??
