IN CIVIL ENGINEERING DESIGN WHY WE ARE USING LIMIT STATE
METHOD IS BEST?
I THINK WORKING STRESS METHOD IS BEST?
EX; FOR COLOUMN DESIGN IN LIMIT STATE METHOD AST
IS;1913SQ.MM
SAME TIME WORKING STRESS METHOD IS ;2213.
SO I THINK WORKING STRESS METHOD IS VERY STRONG COMPARE
THEN LIMIT STATE METHOD?
MY OPENING IS CORRECT OR NOT? PLS TO EXPLAIN SIRS
- 12 Answers
- 18745 Views
- I also Faced
- E-Mail Answers
Answer Posted / britto/ram/saravanan
in WORKING STRESS METHOD,(for ex, if we want to use M20
grade in any place we will use M15 grade), that is minimise
the characteristic strength of the material, this is taken
when u r in designing stage.
in LIMIT STATE METHOD (for ex, we have design a member
takes 1 ton in this method we take 1.5 ton) in this method
we will take the actual charateristic strengtn of the
material.
| Is This Answer Correct ? | 15 Yes | 2 No |
Post New Answer View All Answers
How many square meter can mason layout chb per hour
do you think we shall remove un wanted soil for foundation excavation even if the thickness of the soil strata is more than 8m ?
Difference between pre-tensioning and post-tensioning.
please give me the rates of RCC(CUM), PCC(CUM), Brick Work(CUM), Tile Flooring, Saria Shuttering
what should be the PCC ratio to construct a plinth of (40x40x4)ft...??also its estimated cost??
how to find quantity of concrete in PCC M15
asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream
Define a polyline?
What is the difference between one-way slab and two-way slab?
what is grade intersection?
what is the minimum reinforcement provided in beams,footings,slabs? what is the minimum soil bearing capacity to design a multistorey building
why is M30 grade Concrete use for Foothing & Column M50
What is dead load impact load live load
pls mail some more tecnical qustions at msaranya2610@gmail.com
What was asked in isro civil interview
