What is the Difference between E/P Positioner and I/P
positioner in a control valve? In which applications the
respective positioners are used in?
- 18 Answers
- 70902 Views
- ADCO, I also Faced
- E-Mail Answers
Answer Posted / dipak
Basically both are same. Here letter I stands for Current &
E stands for Electric signal which is nothing but current
signal to operate control valve. It's all depends on
legends we are going to use in a particuler project.
| Is This Answer Correct ? | 38 Yes | 28 No |
Post New Answer View All Answers
How to Calibrate Vibration Probe (Axial, Redial) in field
How to Calibrate Temperature Switch in field
why would you like to join our company
whatis range of marcury filled tempereture gague
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
what is piezoelectric transducer?give an example in power plant n state its principle?
What is 3 selection available when configure the burnout protection for controller
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
What is the difference between modbus,fieldbus & profibus
Draw a group of instruments interlocked to a Pump & Motor?
Describe the function of Accumulator into the Pump
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
