What will be the full load current of 60KVA UPS. Suggest
for this formula.
- 8 Answers
- 32790 Views
- ABC, Sodexo, I also Faced
- E-Mail Answers
Answer Posted / sreenu
Rating of UPS is in KVA, Hence it is just like a
transformer or alternator.
So I(Current)= S (Apperent power)/Voltage only.
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
who can measure the size of power cable?
whats the application of voltage regulation? and whats the voltage regulation's device?
i have some screw comprressor with 630kw power,i have established them with simple star to delta circuit,by the way there is so much inertia when the screw comprressors start, can you offer me contactors power with 400vac or any cataluge to choose the contactors
what is the safety points of vaccum circuit breaker.
What are the necessary solutions needed to be carried out on a malfunctioned earthing mechanism of a VACUUM CIRCUIT BREAKER.(TAMCO)
battery capacity use of made?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
Can u Explain about the electronic trivector meter and the use of data converters in them?
i have applied for junior engineer 2 c&w for Guwahati RRB please send me last five year question paper
What aturn on methods of scr?
Please define ohm’s law for a.c (alternating current)?
What is called grain-oriented laminations?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
A logic circuit that provides a HIGH output if one input or the other input, but not both, is HIGH, is a(n)?
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
