Answer Posted / minal
It is a cos angle between voltage & current.
Also, it is a ratio of resistance to impedance.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why HT armoured cable does not glanding
What is the automatic voltage regulator with servomotor?
What does bode plots shows?
a governer in an Ic engine controls the
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
what are the difference between PLC and embedded
what is the ground fault relay,which purpose it will be use,clearly tell me plz
what do you mean by plant earthing system.
what is the path of thunderlightening? once both a buffalo and a person were standing 5m apart but lightening hit and killed buffalo not person?
If short circuit ratio is high is it bad or good for a machine then tell the reason...
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
explain different losses in a transformer.
what are the dimensions for 200 kva transformer plinth (plateform),in which pcc m20 is used..
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
What is resistance of 50meters, 16sq.mm, single core copper cable?
