What is MODBUS Controller Used for BMS Mointoring???
- 2 Answers
- 6091 Views
- Emerson, I also Faced
- E-Mail Answers
Answer Posted / achuthan
MODBUS is an internationaly accepted protocol for
communicating through RS 484 network. It is used in BMS
communication between master and several slaves. This
protocol is iternationaly accepted .
A protocol defines the rules and regulations and the other
person decodes and understands it. A german communicates a
thing to others in german language, an english man in
english etc. If german is spoken to an english man he may
not understand
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What are the advantages of nichols chart?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
Mention the methods for starting an induction motor?
what is differentila pilot supervision in the incomer control panel in the power station?
What is servo motor and what are different types of servo motor
what is mean by PIR in circuitbreaker and give me detail of that?
What are m circles?
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
difference bewteen reverse current and alternating current
what is doid
Hoe do calculate the Cable size for Amps rating ?
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
