Answer Posted / gunasekaran
1.we can use less no of turns for same voltage level
2. we can put less insulation.
| Is This Answer Correct ? | 9 Yes | 5 No |
Post New Answer View All Answers
why not starting switch first connect in direct on line starter?????
10 Mtr Hight of Lighting Arrestar how much area coverd??
How to calculate size of HT breaker with the help of Amp (current)? Please provide answers with examples.
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
what are the main applications of transistor in non-linear region?
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
what is the transformer turn ratio formula and give some examples?
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
What are the applications of different multistage amplifiers?Plz also write advantages of these amplifiers? Thaaaaaaaaanx
What is lc oscillator?
From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
Why is tan-delta test and capacitor measurement done on alternator?
Don't you have similar question banks related to Oral Certification Examination conducted by Mercantile Marine Departments / Directorate of Shipping, Ministry of Shipping for Electro Technical Officer?
