why commutator is attached with only dc macine

Answer Posted / m.ravi

in dc generator it makes bidirectional current to
unidirectional current
in dc motor it makes unidirectional torque

Is This Answer Correct ?    1 Yes 0 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

Why let through energy not considered for ACB breaker while cable sizing?

1868


What is the reason that the humming sound is coming from the induction furnace panel?

2084


rajha power sector details

1543


I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?

1784


what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?

1498






What is the working principle of servo motor? And explain it.

1408


how diside ct mf exmp.200/5 ct

1650


Transformer cores are laminated in order to A simplify its construction B minimize eddy current loss C reduce cost D reduce hysterisis loss

2841


Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection

7704


Why we are going for converter transformers for DC drives application instead of distribution transformer?

1444


In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?

965


What is meant by Im=30mA@Vk/2. How to know the kee point voltage for CT design

2870


WHAT IS SHORT CIRCUIT STRENGTH OF 100 AMPS MCCB?

1682


what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:

1532


The loads are connected with phase and ground then why current flow as the loads ?

1490