Interested to Buy Any Domain ? << Click Here >> for more details...
what should we do when the CT secodary gets open? how do we
short circuit it? using tester or screw driver? not
dangerous?
- 6 Answers
- 9838 Views
- I also Faced
- E-Mail Answers
Answer Posted / gunasekaran
it may dangerous at full load condition because excessive
high voltage is build up in secondary so we have take
shutdown then only we have use tester or screw driver
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
What is the distance between each insulator in 33kv transformer and how can it calculate
what is cathodic protection and why it use in industries?
How to design the earth grid for lightning protection in an industry
What kind of socket shall be provided for window type air conditioner with cooling capacity upto 18000 BTU/hr
could you measure current in parallel?
Leakage current,un balance current which relay using for high voltage transmission?
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
can we use engine degreaser for electrical motors?
Explain the laying procedure and laying depth of submarine/subsea power cable for 220/400KV system? Also available cable diameter?
what is capacitor voltage transformer?? how it is different from potential transformer?
What are the advantages of a three-phase system over a single-phase system?
What is tan delta & PPM in transformer? and whats its IS value?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
Why HT 11 KV Slipring Motors are connected in star ?
