mix proportion of M20 AND what are different grades below it
Answer Posted / s.stalin babu
M5-1:5:10, M10-1:4:8, M151:3:6, M20-1:2:4, M25-1:1.58:3,
M30-1:1:2(M30-Design Mix)
| Is This Answer Correct ? | 10 Yes | 51 No |
Post New Answer View All Answers
what might be the problem faced in the near future if the M-sand is used in the place of river sand during wall plastering? (As per IS)
Where will be the maximum bending moment in a TEE Beam?
How much quantity of cement and sand required for the inlining of 610mm dia MS pipe 8.7mm thk.Inlining thickness is 10mm and CM ratio is 1:1.5.
Design a reinforced concrete combined footing (rectangular) for two columns located 3.60 metres apart. The overall sizes of the columns are 40cm x 40cm and 69cm x 60cm and the loads on them are 1000 kn and 1500 kn respectively. The space available for the width of the footing is restricted to 180cm. The S.B.C. of the soil is 280 kn/mm2 use M15 concrete.
In the present situation of ban on mining sand from rivers,can we go for formation of earth dam filters viz;Horizantal sand blanket,inclined chimney and filters under rivetment with crushed rock sand of 6mm down size.If so what are the specifications and is there any codal provision for its authentication?
Will water damage concrete?
How to calculate canal slope curvature qty!
How to Rectify deep crack formed on Brick Wall? Explain the method of rectify the defect?
in one SQM plaster how much Cement and sand consumed in ratio 1:4
what should be the PCC ratio to construct a plinth of (40x40x4)ft...??also its estimated cost??
suppose that 156000 sq.ft rcc work builtup are.how many % of brick work to rcc work.
1.what type of the rock is most suitable for wet mix macadam in construction of road? 2.what is the highest maximum dry density and optimum moisture content can be acheive by using most suitable crush rock?
how to control PQI (Project Quality Index)
what discoveries did you have in relation to your course?
What does civil status mean?