WHAT IS THE REASON FOR THE GROUND PIN IS BIGGER IN SIZE
COMPARING TO OTHER PINS?
- 13 Answers
- 12972 Views
- I also Faced
- E-Mail Answers
Answer Posted / arshad
because like safty first,low resistance
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is phase cross over frequency?
why HT armoured cable does not glanding
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
full form of electrical?
why lightning arrestor are made in two stack of insulator but why not cvt
what is vtg limit of earth and neutral at transformer side?
In HI POT test what is reason for applying the AC VOLTS and DC VOLTS in different applications what is the nessesity for this ?
how can motor both beasrings insulation resistance can be check?
What are the site acceptance tests for power cables, DG Sets, LT panels & 30kVA UPS ?
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
What is the difference between PLC and Embeded system
What is PQA???Applications........
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
How many types of faults are there in 3 phase power system?
