Why we should use delta connection in primary and star
connection in an distribution transformer, which converts
400v a.c. voltage to 33kv.
Answer Posted / pankaj malhotra
For distribution transformers, loads are connected to
secondry side. hence, requirement of neutral can be
obtained by connecting secondry of the transformer in star.
Secondly, to reduce or minimise the third harmonics in the
transformers, primary side connection generally done in
delta.
Is This Answer Correct ? | 18 Yes | 4 No |
Post New Answer View All Answers
DESCRIBE THE CONSTRUCTION ANDOPERATION OF BELT CONVEYORS AND SCR CONVEYORS , DRAW NEAT SKETCHES
Why frame of the motor is specified?. If we mention KW and voltage level,automatically frame is decided or separately frame is compulsory to mention?.
What are the two basic types of transformers?
Hello sir, pls send me hpcl technical test papers .i am. Appearing for the exam.
Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards
what is plunger and what's the use of it in motor alignment?
State Maximum Power Transfer theorem.
how to increase senstivity of ct
Differentiate between Zero and Negative sequence current
what is KSR type transmission tower? What is LSR type transmission tower?
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
thyristor controlled APFC panel design parameter?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
Rules and standards of electrical control wiring ?
primery try cell?