How can you justify a fully carged battery by physical
checkup ?
- 12 Answers
- 13310 Views
- Indian Military Services, I also Faced
- E-Mail Answers
Answer Posted / arvind
By touching the positivr & negative of the battery using a heavy wire, IF THE SPARK IS HEAVY THEN IT IS FULLY CHARGED...
| Is This Answer Correct ? | 2 Yes | 7 No |
Post New Answer View All Answers
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
How i can decide that HVDC line is best for transmission.
What is the meaning of C1, C61, C91 cable
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
bus bar design conditions and sizing pls tell me quickly
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
How we can calculate the Amps for the cable Ex:- For 1sqmm wire how many amps we can draw (calculation)
how do i work out the Amps of a incommer if i am running 1 37 KW motor and a 0,75 KW motor and some solinoids
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
whether starting current is limited to rated current of motor through soft starting or it exceeds the rated current?
how flow current in 220 kv line to line
how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.
