what is the effect of power factor in electrical circuit ?
if we mainten power factor near about unity (0.999) our
energy consumption Units increase or decrease?
Answer Posted / rahul verma
Electrical energy is exclusively
generated,transmitted,distributed in the form of
alternating current.therefore the question of power factor
immediately comes in to picture.since most of the loads are
inductive in nature hence have low lagging pf.low pf is
highly undesirable as it causes increase in current,and
additional losses of active power in all the elements from
power station generation till the utilization devices.
if we maintain pf as close to unityour consumption unit
decrease
| Is This Answer Correct ? | 13 Yes | 8 No |
Post New Answer View All Answers
Two electric lamps 40 W, 220 V each are connected in series across 220 V. What is the power consumed by the connection?
If a transformer primary winding operates at 240v, the secondary at 120v and the load is 1500w & the transformer is rated at 92% efficient, what's the current flowing through the primary winding of the transformer? What is the formula for finding this?
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
What is power relay?
What are the three constants associated with a steady state error?
explain the process of commutation in a dc machine. Explain what are inter-poles and why they are required in a dc machine.
How to calulate Locked rotor amper(LRA) for compressor type motors?
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
what is the effect of earth on capacitance in 3-phase and 1- phase transmission line?
what are the sample questions asking to the test cunducting for electrical superwising lisence test?
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
What do you mean by a current transformer?
Why it need to form a capcitor when it not been in use from three or two year. Plz describe it technically.
What are the advantages and disadvantages of short-pitched winding?
A logic circuit that provides a HIGH output if one input or the other input, but not both, is HIGH, is a(n)?