what is the potential difference between line and earth?
Answer Posted / suraj_ojha
It should be less than 1 volt.
Is This Answer Correct ? | 2 Yes | 11 No |
Post New Answer View All Answers
How PSV sizing being done
DEFINE BREAKING CAPACITY OF BUSBAR & HOW IT IS CALCULATED?
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
which protection function should measure RMS value of current&DFT value of current?
Determine the BTU size of an aircon for 20 sq metre room
I need bhel electrical test pattern & paper
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
What are the different types of controllers?
What is the difference between DOL starter and star delta starter
If a high resistance fault occurs,then what are the changes will happen in the system?
where is core-type and shell-type construction suitable for transformers ?
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
what is the difference between neutral and earth